Sunday 27 August 2017

air - A flying fly inside a sealed box on a scale


suppose there is a scale able to measure weight with an uncertainty of $10^{-9}kg$ . On the scale, an airtight plastic chamber is placed. Initially, a fly of mass $10^{-5}kg$ is sitting at the bottom of the chamber, which sits on the scale. At a later point in time the fly is flying around the chamber. Will there be a difference in the observed weight as measured by the scale when the fly is sitting at the bottom of the chamber compared to when it is flying around the chamber at some point in time? If so, what does the value of this difference depend on (I am most concerned with the case where the fly has not touched any surface of the container in enough time for the scale to reach some equilibrium value (or do the pressure variations induced from the flies wings cause constant fluctuations in the scale)?



Answer



If you had a perfect scale, the reading would fluctuate based on


$$\delta w = m\ddot{x}_{cm}$$


$\delta w$ is the size of the fluctuation in the reading, $m$ the total mass on the scale (including fly and air), and $\ddot{x}_{cm}$ the acceleration of the center of mass.


Integrating over time,


$$\int_{time} \delta w(t) = m\Delta(\dot{x}_{cm})$$


Here, $\Delta(\dot{x}_{cm})$ is the change in velocity of the center of mass over the period you observe the readings. Because the velocity of the center of mass cannot change very much, if you integrate the fluctuations over time, you wind find that their average tends towards zero. If the fly begins and ends in the same place and the air is still, the fluctuations integrate out to exactly zero.


Whenever the fly is accelerating up, we expect the reading to be a little higher than normal. When the fly accelerates down, we expect the reading to be a little lower than normal. If the fly hovers in a steady state, the reading will be the same as if the fly were still sitting on the bottom.



A real scale cannot adjust itself perfectly and instantaneously, so we would need to know more details of the scale to say more about the real reading.


No comments:

Post a Comment

Understanding Stagnation point in pitot fluid

What is stagnation point in fluid mechanics. At the open end of the pitot tube the velocity of the fluid becomes zero.But that should result...