I want to calculate a flux on my fpga using the Euler equations with the finite volume method. Unfortunately the values of the state variables differ a lot. For example the pressure has a value of 100000 and the density 1.16. This makes it complicated to calculate on the FPGA. Now I'm wondering if there is a normalized form for the Euler equations with finite volumes, so that the values of the state variables are in the same range. I've tried to set them all to one, but my simulation crashed. I think that's not possible because of the non-linearity of the equations.
Subscribe to:
Post Comments (Atom)
-
A rook stands in the lower left corner of an $m\times n$ chessboard. Alice and Bob alternately move the rook (horizontally or vertically, th...
-
Why can't we use fissions products for electricity production ? As far has I know fissions products from current nuclear power plants cr...
-
Recently I was going through "Problems in General physics" by I E Irodov. In Electromagnetics chapter, there is a question how muc...
-
Yesterday, I understood what it means to say that the moon is constantly falling (from a lecture by Richard Feynman ). In the picture below ...
-
I am having trouble understanding how centripetal force works intuitively. This is my claim. When I have a mass strapped on a string and spi...
-
if $\vec L=I\vec ω$ holds good in all the cases then directions of angular momentum and angular velocity must be parallel always which is no...
-
It is said that immediately after the Big Bang, the fundamental forces of nature were unified. It is also said that later they decoupled, be...
No comments:
Post a Comment